February 19, 2010, Newsletter Issue #172: Installing the forward section of a flare

Tip of the Week

The forward portion of a flare attaches to the door and installs essentially the same way as the rear portion, with one important exception. You test fit the part, outline it with a grease pencil, prepare the surface and attach the part using double-sided tape. So far, so good.

But when you get to the actual mounting of the part, you will have to drill and attach screws into the metal surface of the door. To mark the location of the screws, apply colored modeling clay on the predrilled screw holes on the bottom of the part.

* Position the part properly and press down firmly.
* You can now see where on the door you have to pre-drill your holes.
* Go ahead and pre-drill the screw holes in the door using the markings as guides.
* Using self-tapping screws secure the part in place; then remove the tape backing.

Now you are ready to install the front fender flare on the forward wheel well. The front flare attaches just like rear one. Do the same on the other side and you are fully flared and raring to go.

About LifeTips

Now one of the top on-line publishers in the world, LifeTips offers tips to millions of monthly visitors. Our mission mission is to make your life smarter, better, faster and wiser. Expert writers earn dough for what they know. And exclusive sponsors in each niche topic help us make-it-all happen.

Not finding the advice and tips you need on this Auto Accessories Tip Site? Request a Tip Now!


Guru Spotlight
Sherril Steele-Carlin